KNX添加空调，控制模式对应不上如何解决

萝卜斯基

knx:
  climate:
    - name: "客厅地暖"
      temperature_address: "11/4/0"
      target_temperature_address: "13/3/0"
      target_temperature_state_address: "14/3/0"
      temperature_step: 1.0
      min_temp: 16.0
      max_temp: 35.0
      on_off_address: "13/1/0"
      on_off_state_address: "14/1/0"
      operation_modes: ['STANDBY', 'COMFORT', 'BUILDING_PROTECTION', 'ECONOMY', 'AUTO'] 
      operation_mode_address: "13/2/0"
      operation_mode_state_address: "14/2/0"
      command_value_state_address: "14/2/0"

    - name: "客厅空调"
      temperature_address: "11/4/0"
      target_temperature_address: "12/3/0"
      target_temperature_state_address: "11/3/0"
      temperature_step: 1.0
      min_temp: 16.0
      max_temp: 35.0
      on_off_address: "12/0/0"
      on_off_state_address: "11/0/0"
      controller_modes: ['Cool',  'Heat', 'Fan only', 'Dry', 'Auto', 'Off'] 
      controller_mode_address: "12/1/0"
      controller_mode_state_address: "11/1/0"
      command_value_state_address: "11/1/0"
      operation_modes: ['AUTO', 'BUILDING_PROTECTION', 'STANDBY', 'COMFORT'] 
      operation_mode_address: "12/2/0"
      operation_mode_state_address: "11/2/0"
      command_value_state_address: "11/2/0"

复制代码

客厅空调，控制模式有些是对的，有些是反的；另外，没法用NODERED，一用NODERED，KNX就掉线，应该是厂家只允许一个接入