esp8266+ld2410人体传感器

tanhanjiu

esphome:
  name: esphome-web-cb568c
  friendly_name: ESPHome Web cb568c

esp8266:
  board: nodemcuv2

# Enable logging
logger:
  baud_rate: 0
# Enable Home Assistant API
api:
  encryption:
    key: "GX0rPi9teOIPEEE37M73xD6NNYIePyC4CMCd8F5EYXQ="

ota:


wifi:
  ssid: "???"
  password: "!!!!!!!!!!!"

  # Enable fallback hotspot (captive portal) in case wifi connection fails
  ap:
    ssid: "Esphome-Web-Cb568C"
    password: "12345678"

captive_portal:
uart:
  id: uart1
  tx_pin: GPIO1
  rx_pin: GPIO3
  baud_rate: 256000
  parity: NONE
  stop_bits: 1

ld2410:
  timeout: 61s
  max_move_distance : 6m
  max_still_distance: 0.75m
  g0_move_threshold: 50
  g0_still_threshold: 0
  g1_move_threshold: 50
  g1_still_threshold: 0
  g2_move_threshold: 40
  g2_still_threshold: 40
  g3_move_threshold: 30
  g3_still_threshold: 40
  g4_move_threshold: 20
  g4_still_threshold: 30
  g5_move_threshold: 15
  g5_still_threshold: 30
  g6_move_threshold: 15
  g6_still_threshold: 20
  g7_move_threshold: 15
  g7_still_threshold: 20
  g8_move_threshold: 15
  g8_still_threshold: 20

sensor:
  - platform: ld2410
    moving_distance:
      name : Moving Distance
    still_distance:
      name: Still Distance
    moving_energy:
      name: Move Energy
    still_energy:
      name: Still Energy
    detection_distance:
      name: Detection Distance

binary_sensor:
  - platform: ld2410
    has_target:
      name: Presence
    has_moving_target:
      name: Moving Target
    has_still_target:
      name: Still Target

复制代码

无法使用，显示未知状态

alabo

是不是用的nodemcu，好像是供电的问题

adamjensen

别把密码发出来呀

tangyali

首先检测tx_pin与rx_pin有没有按规范反接

tanhanjiu

alabo 发表于 2023-3-22 09:18
是不是用的nodemcu，好像是供电的问题

不是，单独供电

tanhanjiu

tangyali 发表于 2023-3-22 12:54
首先检测tx_pin与rx_pin有没有按规范反接

正反都试过

tangyali

tanhanjiu 发表于 2023-3-23 22:18
正反都试过

反正我用esp32也不省心，只要用这种方式接入，芯片就总是在有人状态显示无人，只接io输出口就没事，估计是bug吧