node-red代码向mqtt发送switch,homeassistant不能更改状态

hunl0613 · 发表于 2023-12-23 14:51:20

本帖最后由 hunl0613 于 2023-12-23 15:23 编辑

msg.payload={  
   "name":"38度开关",  
   "command_topic": "homeassistant/switch/wanghe_switch_38/set",  
   "state_topic":"homeassistant/switch/wanghe_switch_38/state",
   "unique_id":"wh101",
   "device":{  
      "identifiers":[  
         "wanghe101"  
      ],  
      "name":"热水器"  
      
   },
   "payload_on": "ON",
   "payload_off": "OFF",
   "state_on": "ON",
   "state_off": "OFF",
   "qos": 0,
   "retain": true,
   "command_on_template": "ON",
   "command_off_template": "OFF",
   "state_on_template": "ON",
   "state_off_template": "OFF",
   "value_template": "{{ value_json.state }}"
}
msg.topic = "homeassistant/switch/wanghe_switch_38/config";
msg.retain = true; // 保留配置主题
return msg;

请问上面node-red代码向mqtt发送switch，发送ON或OFF到homeassistant/switch/wanghe_switch_38/state主题可以更改状态，但在homeassistant中mqtt生成的switch中没法点击更改状态，添加代码 "optimistic": true后可以更改状态，但显示的开关样式为turn而不是switch,

请问如何解决让按钮可以更改状态并样式为switch

flows .rar (1.46 KB, 下载次数: 0)

		自动登录	找回密码
密码			立即注册

[求助] node-red代码向mqtt发送switch,homeassistant不能更改状态