【求助】SonOff Touch刷机后无法使用

jscsmlxj

                               
登录/注册后可看大图

                               
登录/注册后可看大图

The Sonoff-Touch button is not connected to GPIO0 and can hence not be used to bring the module into Programming Mode. A connection between GPIO0 and GND needs to be made manually. GPIO0 can be found on the right side of the ESP8285 and is the second pin from the bottom, as can be seen on the pictures.

jscsmlxj

jscsmlxj 发表于 2017-6-13 10:13
The Sonoff-Touch button is not connected to GPIO0 and can hence not be used to bring the module  ...

Sonoff-Touch按钮没有连接到GPIO0，因此不能用于使模块进入编程模式。需要手动进行GPIO0和GND之间的连接。GPIO0可以在ESP8285的右侧找到，并且是底部的第二个引脚，可以在图片上看到。